Once you have good loop (say 8 bars), the loop adjustments allow you to move it through the song. Nudge the entire loop to the right a smidgen. Nudge the entire loop to the left a smidgen. Shift the loop to the right one loop length. Shift the loop to the left one loop length. Select Loop, to reveal the Loop Adjustment Buttons, and shift the entire loop position or adjust the loop’s duration. The loop adjustment scroll slider is used to change the start (A) and end (B) positions. Select B and use the loop adjustment control to modify the B slider (loop end) position Select A and use the loop adjustment control to modify the A slider (loop start) position Make fine adjustments while the loop is playing and slow down the tempo to get it just right. Use the scroll slider to adjust loop ends or the Loop Adjustment buttons to move or resize the entire loop. “Delete a Loopmark (Add button changes to Delete when positioned on a Loopmark) “įirst choose what to adjust: the loop ends and or the entire loop. Note: this is a three state, button see Loop Delay. Move A to beginning and B to end of songĮnable/disable repeating of the selected portion of the songĪdd a configurable delay (silence) before repeating the loop. Move the B Slider (loop end) to the playhead position Move the A Slider (loop start) to the playhead position While the song is paused navigate to anywhere in the song, such as an existing Audiomark, and tap the A or B buttons to move the sliders. Tap button to reset the sliders back the start and end of the song.Adjust the Loop ends by dragging the sliders or using the Fine Adjust controls.Tap to enable looping and listen to your loop.Tap A where you want the loop to begin.Use the wave form to help position the sliders in a valley for a smoother loop. Tap the A or B button to move the corresponding slider to the current playhead position and the button to reset the sliders back the start and end of the song. Tap the slider to move the playhead to the slider. Dragging the slider to the edge of the screen scrolls the zoomed view. The time appears above the slider when selected (long tap). Drag these in the song view or the zoomed view windows to set the start (IN) and end (OUT) of a loop. The A and B sliders are displayed with the Loop Controls are activated. The Loop portion of the wave form will change to orange when Looping is enabled.
The current loop is defined by the A and B sliders. Tap the Mode Selector and select Loop Mode Do you want to hear that part again, practice the solo a few hundred times or just play along to a cool groove for an hour? Anytune can help you repeat any part of a song.
0 kommentar(er)
